![]() ![]() If the information I've provided was helpful, give us some reinforcement by clicking the "Solution Accepted" on this Post and it will also help other community members with similar issue. If you receive a prompt to print a calibration page, do so.Īlso ensure the printer has the latest Firmware Reinsert the ink cartridges, and then close the ink cartridge access door. Wait until the warm-up period finishes and your printer is idle and silent before you proceed. The printer lights might flash, and the carriage might move. The printer might go through a warm-up period. Turn on the printer, if it does not automatically turn on. Reconnect the power cord to the rear of the printer. NOTE: HP recommends connecting the printer power cord directly to a wall outlet. Plug the power cord back into the wall outlet. With the printer turned on, disconnect the power cord from the rear of the printer and from the wall outlet or power strip. Remove the ink cartridges from the printer and clean the electrical contacts with a lint free cloth If your printer has a network or wireless connection, leave it connected. Disconnect the USB cable from the rear of the printer. Wait until the printer is idle and silent before you continue. There are no settings for Single Cartridge Mode
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |